Cisco ESR10008 Hardware Installation Guide - Page 85
Managing the File Systems, File Systems
![]() |
UPC - 746320761510
View all Cisco ESR10008 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
Chapter 4 Starting and Configuring the Router Managing the File Systems Step 3 Enter the format diskn: command at the privileged EXEC mode prompt to format the disk. The following example shows the display after you enter the format disk0: command: Router# format disk0: All sectors will be erased, proceed? [confirm] Enter volume id (up to 30 characters): MyNewdisk Formatting sector 1 Format device slot0 completed Router# The Flash memory disk is now ready for use. Managing the File Systems This section describes the file systems used on the Cisco 10008 series router and provides procedures for performing the following basic file system tasks: • File Systems, page 4-7 • Copying the Startup Configuration to the Running Configuration, page 4-8 • Managing Configuration Files Larger than NVRAM, page 4-8 File Systems The Cisco 10008 series router includes the file systems described in Table 4-1. Table 4-1 Cisco 10008 Series Router Principal File Systems File System CLI Name Bootflash bootflash: Secondary bootflash sec-bootflash: NVRAM nvram: Secondary NVRAM sec-nvram: System system: Disk 0 Disk 1 Slot 0 Slot 1 Secondary Disk 0 Secondary Disk 1 Secondary Slot 0 Secondary Slot 1 disk0: disk1: slot0: slot1: sec-disk0: sec-disk1: sec-slot0: sec-slot1: FTP ftp: TFTP tftp: RCP rcp: Description Stores image and dump files. Typically stores the system default configuration file and startup configuration file. Stores the running configuration and other system files. Disk refers to an ATA Flash disk (48 or 128 MB). Slot refers to a Flash memory card (8, 16, or 20 MB). 0 refers to the left slot on the PRE. 1 refers to the right slot on the PRE. Secondary refers to the secondary PRE in a redundant system. Protocols used for accessing files that are stored remotely. Flash memory disks and the smaller Flash memory cards use similar commands. The primary syntax change is that disk0: or disk1: refers to Flash memory disks, and slot0: or slot1: refers to Flash memory cards. OL-0659-13 Cisco 10008 Router Hardware Installation Guide 4-7
![](/manual_guide/products/cisco-10008-hardware-installation-guide-4642de6/85.png)