Cisco ESR10008 Hardware Installation Guide - Page 53

Chapter 3 Installing the Cisco 10008 Router Figure 3-9 Attaching the Cable Management Bracket Non-Rack Installation POWER FAULT MISWIRE POWER FAULT MISWIRE RX TX CARRIER LOOP ALARM CARRIER RX TX LINK FANS OK FAFILAUNRE FMAFUILALUNTRI-E WrbseyemhsdetoeonvmnahelsoaihtnnCusduwtAdnarUodepwTeppnIrliaOntcwwgNeioltmlhmoiescnincftauumntre.utsrsaotyr, 1 CISCO 10000 2 CISCO 10000 3 CISCO 10000 4 CISCO 10000 FAIL FAIL FAIL FAIL LOOP CARALRAIERRM LOOP CARALRAIERRM 0 0 1 1 2 2 3 3 4 4 5 5 SSLLOOTT01 SSLLOOTT01 0A PROCESSOR ONLY0B CISCO 10000 CISCO 10000 CONSOLE AUX ELAICTNHTKIEVRITNYET CONSOLE AUX LAEICTNHTKIEVRITNYET LOOP CARALRAIERRM LOOP CARALRAIERRM LOOP CARALRAIERRM FAIL FAIL FAIL 5 CISCO 10000 0 6 CISCO 10000 0 7 CISCO 10000 0 1 1 1 2 2 2 3 3 3 4 4 4 5 5 5 FAIL 8 CISCO 10000 ACO CMRAIJTOICRAL MINOR SFATAILTUS ACO CMRAIJTOICRAL MINOR SFATAILTUS PROCESSOR ONLY OC-12/STM-4 POS SM-IR 6XCT3-DS0 6XCT3-DS0 6XCT3-DS0 PERFORMANCE ROUTING ENGINE PERFORMANCE ROUTING ENGINE 6XCT3-DS0 6XCT3-DS0 CH OC-12-DSO SM-IR GIGABIT ETHERNET 76223 Step 5 Attach the cable management bracket to the bottom of the chassis (Figure 3-9). Note The cable management bracket consists of two pieces (the cable guide and channel), and is shipped assembled. If you want to use the cable guide only, you can remove the channel by loosening the captive screws before attaching the cable guide to the chassis. Step 6 Step 7 Check that all - Ejector levers are in the closed position. - Chassis mounting screws are tight. - PRE and line card captive screws are tight. Go to the "Connecting the Chassis to Ground" section on page 3-13 to continue the installation. Non-Rack Installation The chassis should already be in the area where you will install it. If you have not determined where to install your chassis, see the "Receiving the Cisco 10000 Series Router" section on page 2-14 for information about site considerations. OL-0659-13 Cisco 10008 Router Hardware Installation Guide 3-11