Cisco ESR10008 Hardware Installation Guide - Page 81
Startup Display, Basic Configuration Using the Setup Facility
UPC - 746320761510
View all Cisco ESR10008 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Chapter 4 Starting and Configuring the Router Configuring the Cisco 10008 Router at Startup Startup Display When you power on your Cisco 10008 router or execute the reload command, the console screen displays a message similar to the following: Restricted Rights Legend Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Cisco Internetwork Operating System Software IOS (tm) 10008 Software (C10K-P6-M), Experimental Version 12.0(20000413:055718) [20000413:010004 104] Copyright (c) 1986-2000 by cisco Systems, Inc. Compiled Thu 13-Apr-00 04:20 by chrel Image text-base: 0x60008900, data-base: 0x60A6E000 cisco C10008 (CRE-RP) processor with 114688K/16384K bytes of memory. Processor board ID 00018655341 R7000 CPU at 262Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache Unknown midplane, Version 1.0 Last reset from register reset Toaster processor tmc0 is running. Toaster processor tmc1 is running. 1 Ethernet/IEEE 802.3 interface(s) 1 FastEthernet/IEEE 802.3 interface(s) 509K bytes of non-volatile configuration memory. 40960K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes). 32768K bytes of Flash internal SIMM (Sector size 256KB). Press RETURN to get started! Basic Configuration Using the Setup Facility The first time you power on a Cisco 10008 router, the setup facility starts. You can also initiate the facility by running the setup command in privileged EXEC mode. This facility helps you enhance a default configuration that already exists on the Cisco 10008 router. The setup facility uses a question and answer sequence called the System Configuration Dialog to walk you through configuring the router. You do not have to configure the interfaces immediately; however, you cannot enable the interfaces or connect them to any networks until you have configured them. Tip Basic configuration setup is often used as a quick way to achieve network connectivity, allowing you to retrieve a configuration file from a TFTP server. OL-0659-13 Cisco 10008 Router Hardware Installation Guide 4-3