Cisco ESR10008 Hardware Installation Guide - Page 42
Required Tools and Equipment, Verifying Contents After Unpacking
![]() |
UPC - 746320761510
View all Cisco ESR10008 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Required Tools and Equipment Chapter 2 Preparing for Installation Step 2 With the other hand, grasp the top rear of the chassis under the air exhaust and carefully lift the chassis as shown in Figure 2-4. Required Tools and Equipment The tools and equipment listed below are recommended as the minimum necessary to install the Cisco 10008 router. You may need additional tools and equipment to install associated equipment and cables. You may also require test equipment to check electronic and optical signal levels, power levels, and communications links. • Number 2 Phillips screwdriver • A 3/16-inch flat-blade screwdriver • A 1/4-inch flat-blade screw driver • Antistatic mat or antistatic foam • An electrostatic discharge (ESD) grounding strap or the disposable ESD strap shipped with the system • Tape measure (optional) • Level (optional) Refer to the "Connecting the Chassis to Ground" section on page 3-13 for specific tool and equipment requirements to connect the chassis to ground. Verifying Contents After Unpacking Power cables, manuals, and other additional items are packaged in separate boxes. After you have unpacked the system to verify that you have received all of the required components. Using the packing list as a guide, take the following steps to check the contents of the Cisco 10008 router shipping container: Step 1 Step 2 Check the contents of the boxes containing accessory items. Verify that you have received all equipment listed in your order, including the following: • System hardware and software documentation • Any optional equipment that you ordered, such as transceivers (GBICs), flash cards, cables, or special connectors Check that all line cards you ordered are installed in the chassis (including PCMCIA flash cards installed in the PRE). Ensure that the configuration matches the packing list. 2-16 Cisco 10008 Router Hardware Installation Guide OL-0659-13
![](/manual_guide/products/cisco-10008-hardware-installation-guide-4642de6/42.png)