Dell Brocade 6520 MIB Reference Supporting Fabric OS v7.1.0 - Page 230

9 Connectivity unit group TABLE 75 Object and OID connUnitControl 1.3.6.1.3.94.1.6.1.22 connUnitContact 1.3.6.1.3.94.1.6.1.23 connUnitLocation 1.3.6.1.3.94.1.6.1.24 connUnitEventFilter 1.3.6.1.3.94.1.6.1.25 connUnitNumEvents 1.3.6.1.3.94.1.6.1.26 connUnitMaxEvents 1.3.6.1.3.94.1.6.1.27 connUnitEventCurrID 1.3.6.1.3.94.1.6.1.28 Access Description Read-write Read-write Read-write Read only Read only Read only Read only Controls the addressed connUnit. Each implementation might choose not to allow any or all of these values on a SET. Cold start and warm start are as defined in MIB-II and are not meant to be a factory reset. This is similar to swAdmStatus: • resetConnunitColdStart = reboot • resetConnunitWarmStart = fastboot • offlineConnUnit = disable switch • onlineConnUnit = enable switch • default after reboot = unknown The declaration 1 (unknown) maps to the default value upon rebooting, and 2 (invalid) is not applicable. Declarations 3 and 4 perform the same operation-a cold boot of the switch. Possible values are: • unknown (1) • invalid (2) • resetConnUnitColdStart (3): Reboot. Performs a switch reboot. • resetConnUnitWarmStart (4): Fastboot. The addressed unit performs a Warm Start reset. • offlineConnUnit (5): Disable switch. The addressed unit puts itself into an implementation-dependant offline state. In general, if a unit is in an offline state, it cannot be used to perform meaningful Fibre Channel work. • onlineConnUnit (6): Enable switch. The addressed unit puts itself into an implementation-dependant online state. In general, if a unit is in an online state, it is capable of performing meaningful Fibre Channel work. Contact information for this connectivity unit. Displays the same value as sysContact. Changing the value in this variable causes the value in sysContact to also be changed. Location information for this connectivity unit. Displays the same value as sysLocation. Defines the event severity logged by this connectivity unit. All events of severity less than or equal to connUnitEventFilter are logged in connUnitEventTable. Always returns value 9 (debug). Number of events currently in connUnitEventTable. Fabric OS currently supports 1024 raslog events. Maximum number of events that can be defined in connUnitEventTable. This value ranges from 0 to 1024. The last-used event ID (connUnitEventId). Every RASLOG message has RASLOG number and this represents the RASLOG number. Maximum is 2147483647 (231-1). 210 Fabric OS MIB Reference 53-1002750-01