Dell Brocade 6520 MIB Reference Supporting Fabric OS v7.1.0 - Page 234

9 Connectivity unit group TABLE 75 Object and OID connUnitPortType 1.3.6.1.3.94.1.10.1.3 Access Read only connUnitPortFCClassCap Read only 1.3.6.1.3.94.1.10.1.4 Description The port type. For EX_Port, VEX_Port and VE_Port, the port type will be shown as other. For a Brocade Access Gateway device, the port type can be either F_Port (f-port) or N_Port (n-port) only. Possible values are: • unknown (1) • other (2) • not-present (3) • hub-port (4) • n-port (5) End port for fabric. • l-port (6) End port for loop. • fl-port (7) Public loop. • f-port (8) Fabric port. • e-port (9) Fabric expansion port. • g-port (10) Generic fabric port. • domain-ctl (11) Domain controller. • hub-controller (12) • scsi (13) Parallel SCSI port. • escon (14) • lan (15) • wan (16) • ac (17) AC power line. (Not supported in Fabric OS v2.6.1.) • dc (18) DC power line. (Not supported in Fabric OS v2.6.1.) • ssa (19) Serial storage architecture. (Not supported in Fabric OS v2.6.1.) Bit mask that specifies the classes of service capability of this port. If this is not applicable, return all bits set to 0. The bits have the following definition: • unknown 0 • class-f 1 • class-one 2 • class-two 4 • class-three 8 • class-four 16 • class-five 32 • class-six 64 For an F_Port or FL_Port, this value is 0x000C. For a G_Port or E_Port, this value is 0x000D. For a Brocade Access Gateway, both the F_Port and N_Port this value is 0x0008. An Access Gateway supports class-three services only, therefore the value is 8 for both port types. connUnitPortFCClassCap attribute is dependent on the state of the port, that is, whether the port is online or offline. If the port is offline, the class service of U port will be shown as value of onnUnitPortFCClassCap. If it is online, then this mib attribute value will be equal to class service corresponding to the port type (F, E, L port.) 214 Fabric OS MIB Reference 53-1002750-01