Dell Brocade 6520 MIB Reference Supporting Fabric OS v7.1.0 - Page 238

9 Connectivity unit group TABLE 75 Object and OID connUnitPortControl 1.3.6.1.3.94.1.10.1.16 Access Description Read-write Controls the addressed connUnit's port. Valid commands are: resetConnUnitPort If the addressed connUnit allows this operation to be performed to this port, the addressed port performs a vendor-specific reset operation. Examples of these operations are: • The Link Reset protocol. • The Loop Initialization protocol. • Resynchronization occurring between the transceiver in the addressed port to the transceiver to which the port is connected. bypassConnUnitPort If the addressed connUnit allows this operation to be performed to this port, the addressed port performs a vendor-specific "bypass" operation. Examples of these operations are: • Transitioning from online to offline. • A request (NON-PARTICIPATING) command to the loop port state machine. • Removal of the port from an arbitrated loop by a hub. unbypassConnUnitPort If the addressed connUnit allows this operation to be performed to this port, the addressed port performs a vendor-specific "unbypass" operation. Examples of these operations are: • The Link Failure protocol. • A request (PARTICIPATING) command to the loop port state machine. • Addition of the port to an arbitrated loop by a hub. offlineConnUnitPort If the addressed connUnit allows this operation to be performed to this port, the addressed port performs a vendor-specific offline operation. Examples of these operations are: • Disabling a port's transceiver. • The Link Failure protocol. • Request (NON-PARTICIPATING) command to the loop port state machine removal of the port from an arbitrated loop by a hub. onlineConnUnitPort If the addressed connUnit allows this operation to be performed to this port, the addressed port performs a vendor-specific online operation. Examples of these operations are: • Enabling a port's transceiver. • The Link Failure protocol, request (PARTICIPATING) command to the loop port state machine. • Addition of the port from an arbitrated loop by a hub. Each implementation might choose not to allow any or all of these values on a SET. If the management station uses in-band communication (FC-IP) with the switch, either of the two following actions might result in a loss of in-band communication with the switch. • Disabling the FC port that is connected to the management station • Disabling the embedded port 218 Fabric OS MIB Reference 53-1002750-01