Dell Brocade 6520 MIB Reference Supporting Fabric OS v7.1.0 - Page 84

3 Alarm group TABLE 21 Object and OID Access etherHistoryUndersizePkt Read only s 1.3.6.1.2.1.16.2.2.1.10 etherHistoryOversizePkts Read only 1.3.6.1.2.1.16.2.2.1.11 etherHistoryFragments Read only 1.3.6.1.2.1.16.2.2.1.12 etherHistoryJabbers Read only 1.3.6.1.2.1.16.2.2.1.13 etherHistoryCollisions 1.3.6.1.2.1.16.2.2.1.14 etherHistoryUtilization 1.3.6.1.2.1.16.2.2.1.15 Read only Read only Description The number of packets received during this sampling interval that were less than 64 octets (excluding framing bits but including FCS octets) but were otherwise well formed. The number of packets received during this sampling interval that were longer than 1518 octets (excluding framing bits but including FCS octets) but were otherwise well formed. The total number of packets received during this sampling interval that were less than 64 octets (excluding framing bits but including FCS octets) and either had a bad Frame Check Sequence (FCS) with an integral number of octets (FCS Error) or a bad FCS with a non-integral number of octets (Alignment Error). The number of packets received during this sampling interval that were longer than 1518 octets (excluding framing bits but including FCS octets), and had either a bad Frame Check Sequence (FCS) with an integral number of octets (FCS Error) or a bad FCS with a non-integral number of octets (Alignment Error). The best estimate of the total number of collisions on this Ethernet segment during this sampling interval. The best estimate of the mean physical layer network utilization on this interface during this sampling interval, in hundredths of a percent. Alarm group TABLE 22 Object and OID alarm 1.3.6.1.2.1.16.3 alarmTable 1.3.6.1.2.1.16.3.1 alarmEntry 1.3.6.1.2.1.16.3.1.1 alarmIndex 1.3.6.1.2.1.16.3.1.1.1 alarmInterval 1.3.6.1.2.1.16.3.1.1.2 alarmVariable 1.3.6.1.2.1.16.3.1.1.3 Access Not accessible Not accessible Not accessible Read only Read-write Read-write Description A list of alarm entries. A list of parameters that set up a periodic checking for alarm conditions. An alarm is created using the rmon alarm command. A list of alarm entries. A list of parameters that set up a periodic checking for alarm conditions. An index that uniquely identifies an entry in the alarm table. Each such entry defines a diagnostic sample at a particular interval for an object on the device. The interval in seconds over which the data is sampled and compared with the rising and falling thresholds. The object identifier of the particular variable to be sampled. 64 Fabric OS MIB Reference 53-1002750-01