Dell Brocade G620 Hardware Installation Guide - Page 43
Attaching the front brackets to the device
![]() |
View all Dell Brocade G620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Attaching the front brackets to the device 1. Attaching the front brackets to the device on page 43 2. Attaching the front brackets to the rack on page 43 3. Attaching the rear brackets to the rack on page 44 4. Attaching the rear brackets to the device on page 45 Attaching the front brackets to the device Complete the following steps to attach the front brackets to the device. 1. Position the right front bracket with the flat side against the right side of the device, as shown in Figure 16 . 2. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then into the holes on the side of the device. Use the upper and lower screw holes, leaving the center holes empty. 3. Repeat step 1 and step 2 to attach the left front bracket to the left side of the device. 4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg). 1 The Brocade device 2 Front brackets, right and left 3 Screws, 8-32 x 5/16-in., flathead Phillips FIGURE 16 Attaching the front brackets Attaching the front brackets to the rack Complete the following steps to install the device in the rack. Brocade G620 Hardware Installation Guide 43 53-1003990-01
![](/manual_guide/products/dell-brocade-g620-hardware-installation-guide-12e7feb/43.png)