Dell OptiPlex GX1 Dell OptiPlex GX1/GX1p Managed PC and OptiPlex NX1 Net PC S - Page 153
the upright position.
View all Dell OptiPlex GX1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
The computer has a removable expansion-card cage. The expansion-card cage contains the hard-disk drive, the riser board, and any installed expansion card. You must remove the expansion-card cage to remove or install the hard-disk drive, an expansion card, or the riser board. expansion-card cage EIDE cable DC power cable securing lever slots (2) tabs (2) To remove the expansion-card cage, follow these steps: 1. Disconnect any external cables from the expansion card if one is installed. 2. Disconnect the DC power cable and the EIDE cable from the back of the hard-disk drive. 3. Rotate the securing lever toward the back of the computer until it stops in the upright position. 4. Lift the expansion-card cage up and away from the computer. To replace an expansion-card cage, keep it flush against the left side of the chassis to ensure that the two cage slots engage the tabs on the left side of the computer. Press gently downward on the back-right corner of the expansion-card cage while rotating the securing lever forward. Removing and Replacing Parts on the OptiPlex NX1 Net PC Chassis 7-9