Dell OptiPlex GX1 Dell OptiPlex GX1/GX1p Managed PC and OptiPlex NX1 Net PC S - Page 92
on the SEC cartridge release latches and then carefully orient the assembly
View all Dell OptiPlex GX1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
To remove the SEC cartridge/heat sink assembly, follow these steps: 1. Remove the system power supply. 2. Locate the SEC cartridge/heat sink assembly. 3. Disconnect the microprocessor fan connector from the 3-pin connector on the system board (labeled "FAN"), located between the SERIAL2 connector and the MONITOR connector. 4. Release the two securing clips near the base of the heat sink from the metal standoffs. 5. Locate and press inward on the SEC cartridge release latches (located directly on top of the SEC cartridge adjacent to the heat sink assembly) until the latches click. 6. Lift the SEC cartridge/heat sink assembly out of its guide bracket assembly/connector on the system board. NOTE: When installing the SEC cartridge/heat sink assembly, press outward on the SEC cartridge release latches and then carefully orient the assembly and press firmly with up to 25 pounds of force to mate the SEC cartridge with its connector. The SEC cartridge release latches will click into the locked position as the assembly is seated. battery BATTERY socket To remove the system battery, follow these steps: 1. If possible, boot the system and enter the System Setup program. Then record important system configuration information (see Appendix A, "System Setup Program," for details). 4-20