Dell OptiPlex GX1 Dell OptiPlex GX1/GX1p Managed PC and OptiPlex NX1 Net PC S - Page 82
front of the bracket; then install the four screws, but do not tighten them. Align
View all Dell OptiPlex GX1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
drive-mounting screws (4) front of computer To remove a 5.25-inch drive assembly, follow these steps: 1. Remove the 3.5-inch diskette drive assembly. 2. Disconnect the DC power cable and the interface cable from the back of the 5.25-inch drive. 3. Lift the 5.25-inch drive assembly straight up and out of the chassis. 4. Lay the 5.25-inch drive assembly upside down; then remove the four screws attaching the drive to the bracket. When you replace the 5.25-inch drive, place the front of the drive toward the front of the bracket; then install the four screws, but do not tighten them. Align the screws with the score marks on the bracket, and tighten the screws in the order stamped on the bottom of the bracket. Check the alignment of the computer cover around the 5.25-inch drive bezel. Adjust the drive forward or backward on the bracket to align it. 4-10