Dell OptiPlex GX1 Dell OptiPlex GX1/GX1p Managed PC and OptiPlex NX1 Net PC S - Page 85
If reinstalling an ISA expansion card into the expansion-card cage, be sure
View all Dell OptiPlex GX1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
The computer has a removable expansion-card cage. The expansion-card cage contains the riser board and any installed expansion cards. Dell recommends that you remove the expansion-card cage first before removing or installing expansion cards. If you are not removing any of the expansion cards, leave the external cables attached to the expansion cards. lever expansion-card cage ISA expansion-card end support side support hole notch To remove an expansion-card cage, follow these steps: 1. Rotate the lever toward the back of the computer until it stops in the upright position. 2. Lift the expansion-card cage up and away from the computer. To replace an expansion-card cage, keep it flush against the chassis to ensure that the lever engages the notch in the chassis when the lever is depressed. If reinstalling an ISA expansion card into the expansion-card cage, be sure to slip the end of the ISA expansion card into the plastic ISA expansion-card end support. The ISA expansion-card end support should not be removed; however, if it is accidentally removed, reinstall it by first inserting its top tab into the side support hole and then sliding the bottom two tabs into the two support holes on the chassis floor. Removing and Replacing Parts on the Low-Profile Chassis 4-13