Dell PowerEdge R240 EMC PowerEdge R240 Installation and Service Manual - Page 73
Installing the processor
View all Dell PowerEdge R240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Figure 54. Removing the processor Next steps 1. Install the processor. 2. Install the heat sink. Installing the processor Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the air shroud. 4. Remove the heat sink. Steps 1. Align the pin-1 indicator of the processor with the triangle on the system board and place the processor on the socket. CAUTION: Do not use force to seat the processor. When the processor is positioned correctly, it engages into the socket. 2. Close the processor shield by sliding it under the retention screw on the system board. 3. Lower the lever and push it under the tab to lock it. Figure 55. Installing the processor Next steps 1. Install the heat sink. NOTE: Ensure that you install the heat sink after you install the processor. The heat sink is necessary to maintain proper thermal conditions. PowerEdge R240 installing and removing system components 73