Dell PowerEdge R240 EMC PowerEdge R240 Installation and Service Manual - Page 86
Installing the system board
View all Dell PowerEdge R240 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Figure 72. Removing the system board Next steps 1. Install the system board. Installing the system board Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. If you are replacing the system board, remove all the components listed in the Removing the system board section. Steps 1. Holding the system board holder, lower the system board into the system. CAUTION: Do not lift the system board by holding a memory module, processor, or other components. CAUTION: Take care not to damage the system identification button while placing the system board into the system. 2. Incline the system board at an angle and align the connectors on the system board with the slots on the rear of the chassis. 3. Slide the system board toward the rear of the chassis until the connectors are firmly seated in the slots. 86 PowerEdge R240 installing and removing system components