Dell PowerEdge R6525 EMC Installation and Service Manual - Page 119
Removing the system battery, Installing the system battery
![]() |
View all Dell PowerEdge R6525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 119 highlights
Figure 97. Removing the system battery 2. To install a new system battery: a. Hold the battery with the positive side facing up and slide it under the securing tabs. b. Press the battery into the connector until it snaps into place. Figure 98. Installing the system battery Next steps 1. Install the expansion card risers. 2. If applicable, connect the cables to one or more expansion cards. 3. Follow the procedure listed in After working inside your system on page 43. 4. Confirm that the battery is operating properly, by performing the following steps: a. Enter the System Setup, while booting, by pressing F2. b. Enter the correct time and date in the System Setup Time and Date fields. c. Exit the System Setup. Installing and removing system components 119
![](/manual_guide/products/dell-poweredge-r6525-emc-installation-service-manual-662b536/119.png)