Dell PowerEdge R6525 EMC Installation and Service Manual - Page 134
Installing the LOM card and rear I/O board
View all Dell PowerEdge R6525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
Figure 110. Removing the LOM card and rear I/O board Next steps 1. Replace the LOM card and rear I/O board. Installing the LOM card and rear I/O board Prerequisites 1. Follow the safety guidelines listed in the Safety instructions on page 42. 2. Follow the procedure listed in the Before working inside your system on page 43. 3. Remove the system board. Steps 1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board. 2. Press the LOM card or rear I/O board until firmly seated on the system board connector. 3. Using a Phillips #2 screwdriver, secure the LOM card or rear I/O board to the system board with screws. 134 Installing and removing system components
Figure 110. Removing the LOM card and rear I/O board
Next steps
1.
Replace the LOM card and rear I/O board
.
Installing the LOM card and rear I/O board
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
on page 42.
2.
Follow the procedure listed in the
Before working inside your system
on page 43.
3.
Remove the system board
.
Steps
1.
Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
2.
Press the LOM card or rear I/O board until firmly seated on the system board connector.
3.
Using a Phillips #2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
134
Installing and removing system components