Dell PowerEdge R6525 EMC Installation and Service Manual - Page 124
Installing the OCP card
![]() |
View all Dell PowerEdge R6525 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
Figure 103. Removing the OCP card Next steps 1. Replace the OCP card. Installing the OCP card Prerequisites 1. Follow the safety guidelines listed in the Safety instructions on page 42. 2. Follow the procedure listed in the Before working inside your system on page 43. 3. Remove the expansion card riser. Steps 1. Open the blue latch on the system board. 2. Slide the OCP card into the slot in the system. 3. Push until the OCP card is connected to the connector on the system board. 4. Close the latch to lock the OCP card to the system. 124 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r6525-emc-installation-service-manual-662b536/124.png)
Figure 103. Removing the OCP card
Next steps
1.
Replace the OCP card
.
Installing the OCP card
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
on page 42.
2.
Follow the procedure listed in the
Before working inside your system
on page 43.
3.
Remove the expansion card riser
.
Steps
1.
Open the blue latch on the system board.
2.
Slide the OCP card into the slot in the system.
3.
Push until the OCP card is connected to the connector on the system board.
4.
Close the latch to lock the OCP card to the system.
124
Installing and removing system components