Dell PowerEdge T550 EMC Installation and Service Manual - Page 113
Installing the BOSS S2 module blank, Removing the BOSS S2 module blank
![]() |
View all Dell PowerEdge T550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Figure 110. Installing the BOSS S2 module blank Next steps Replace the BOSS S2 module. Installing the BOSS S2 module Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Remove the air shroud. 4. If installed, remove the front bezel. 5. Disconnect the cables connected to the system board. Steps 1. If installed, remove the BOSS S2 module blank using a flat head screwdriver. Figure 111. Removing the BOSS S2 module blank 2. Align the BOSS S2 module to the BOSS S2 slot on the chassis and push it into the slot. 3. Using a Phillips 2 screwdriver, secure the BOSS S2 module to the system. Installing and removing system components 113
![](/manual_guide/products/dell-poweredge-t550-emc-installation-service-manual-732b751/113.png)
Figure 110. Installing the BOSS S2 module blank
Next steps
Replace the BOSS S2 module
.
Installing the BOSS S2 module
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Follow the procedure that is listed in
Before working inside your system
.
3.
Remove the air shroud
.
4.
If installed,
remove the front bezel
.
5.
Disconnect the cables connected to the system board.
Steps
1.
If installed, remove the BOSS S2 module blank using a flat head screwdriver.
Figure 111. Removing the BOSS S2 module blank
2.
Align the BOSS S2 module to the BOSS S2 slot on the chassis and push it into the slot.
3.
Using a Phillips 2 screwdriver, secure the BOSS S2 module to the system.
Installing and removing system components
113