Dell PowerEdge T550 EMC Installation and Service Manual - Page 154
Intrusion switch module, Removing the intrusion switch module
View all Dell PowerEdge T550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Figure 160. Installing the system battery Next steps 1. Install the air shroud. 2. Follow the procedure listed in After working inside your system. 3. Confirm that the battery is operating properly, by performing the following steps: a. Enter the System Setup, while booting, by pressing F2. b. Enter the correct time and date in the System Setup Time and Date fields. c. Exit the System Setup. d. To test the newly installed battery, remove the system from the enclosure for at least an hour. e. Reinstall the system into the enclosure after an hour. f. Enter the System Setup and if the time and date are still incorrect, see Getting help section. Intrusion switch module This is a service technician replaceable part only. Removing the intrusion switch module Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Remove the air shroud. NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped. Steps 1. Disconnect the intrusion switch cable from the connector on the system board. 2. Using a Phillips 2 screwdriver, remove the screw securing the intrusion switch to the system. 3. Slide the intrusion switch module out of the slot on the system. 154 Installing and removing system components