Dell PowerEdge T550 EMC Installation and Service Manual - Page 145
Installing the processor and heat sink module
![]() |
View all Dell PowerEdge T550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Figure 148. Installing the heat sink onto the processor Next steps 1. Install the processor heat sink module. 2. Install the air shroud. 3. Follow the procedure listed in After working inside your system. Installing the processor and heat sink module Prerequisites Never remove the heat sink from a processor unless you intend to replace the processor or system board. The heat sink is necessary to maintain proper thermal conditions. 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Remove the air shroud. 4. If installed, remove the processor dust cover. Steps 1. Set the anti-tilt wires to the unlocked position on the heat sink (inward position). Installing and removing system components 145
![](/manual_guide/products/dell-poweredge-t550-emc-installation-service-manual-732b751/145.png)