Dell PowerEdge T550 EMC Installation and Service Manual - Page 121
MicroSD card, Removing the MicroSD card
View all Dell PowerEdge T550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Steps 1. Locate the IDSDM connector on the system board. NOTE: For information on the exact location of IDSDM on system board, see System board jumpers and connector section. 2. Align IDSDM module with the connector on the system board. 3. Press the IDSDM module until firmly seated on the system board. Figure 125. Installing the IDSDM module Next steps 1. Install the MicroSD cards. NOTE: Reinstall the Micro-SD cards into the same slots based on the labels you had marked on the cards during removal. 2. Install the air shroud. 3. Follow the procedure listed in After working inside your system. MicroSD card Removing the MicroSD card Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Remove the IDSDM module. Steps 1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. For more information on the IDSDM module location, see System board jumpers and connectors section. 2. Hold the MicroSD card, and remove them from the IDSDM module. NOTE: Temporarily label each MicroSD card with the corresponding slot number after removal. Installing and removing system components 121