Dell PowerEdge T550 EMC Installation and Service Manual - Page 163
Installing the power interposer board, Removing the PIB
![]() |
View all Dell PowerEdge T550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 163 highlights
Figure 174. Removing the PIB Next steps Replace the power interposer board. Installing the power interposer board Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Remove the air shroud. 4. Remove the PSU. Steps 1. Align the screw holes on the power interposer board (PIB) with the holes on the system. 2. Using the Phillips 2 screwdriver, secure the PIB to the system using the screws. 3. Connect all the disconnected power cables to the PIB. Installing and removing system components 163
![](/manual_guide/products/dell-poweredge-t550-emc-installation-service-manual-732b751/163.png)
Figure 174. Removing the PIB
Next steps
Replace the power interposer board
.
Installing the power interposer board
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Follow the procedure that is listed in
Before working inside your system
.
3.
Remove the air shroud
.
4.
Remove the PSU
.
Steps
1.
Align the screw holes on the power interposer board (PIB) with the holes on the system.
2.
Using the Phillips 2 screwdriver, secure the PIB to the system using the screws.
3.
Connect all the disconnected power cables to the PIB.
Installing and removing system components
163