Dell PowerEdge T550 EMC Installation and Service Manual - Page 139
Removing the processor, Removing a heat sink
![]() |
View all Dell PowerEdge T550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Figure 141. Removing a heat sink Next steps If you are removing a faulty heat sink, replace the heat sink, if not, remove the processor. Removing the processor Prerequisites WARNING: Remove the processor from processor and heat sink module (PHM) only if you are replacing the processor or heat sink. 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Remove the air shroud. 4. Remove the processor heat sink module. CAUTION: You may find the CMOS battery loss or CMOS checksum error displayed during the first instance of powering on the system after the processor or system board replacement which is expected. To fix this, simply go to setup option to configure the system settings. Steps 1. Place the heat sink with the processor side facing up. Installing and removing system components 139
![](/manual_guide/products/dell-poweredge-t550-emc-installation-service-manual-732b751/139.png)