Dell PowerEdge T550 EMC Installation and Service Manual - Page 128
Removing a expansion card, Table 43. Configuration type C2 continued
View all Dell PowerEdge T550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Table 43. Configuration type C2 (continued) Card Type Slot priority Foxconn external adapter 1, 2, 4, 6, 3 H840 Foxconn external adapter 1, 2, 4, 6, 3 HBA355e aPERC HBA11 HBA355i 6 Maximum number of cards 5 5 1 Removing a expansion card Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Remove the air shroud. Steps 1. Disconnect the cables from the expansion card. 2. Press the expansion card latch and push down the latch to open it. 3. Hold the expansion card by the edge, and pull the card up to remove it from the expansion card connector and the system. Figure 128. Removing an expansion card 4. Install the filler brackets by performing the following steps: a. Align the slot on the filler bracket with the tab on the expansion card slot. b. Press the expansion card latch till the filler bracket locks into place. NOTE: Filler brackets must be installed in empty expansion-card slots to maintain FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. 128 Installing and removing system components