Dell PowerEdge T550 EMC Installation and Service Manual - Page 69
Drive bays, Removing the drive bay cage blank
![]() |
View all Dell PowerEdge T550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Figure 61. Installing the 2.5-inch drive backplane Next steps 1. Install the drives. 2. Connect the drive backplane cables to the connector on the backplane. 3. Install the cooling fan cage. 4. Install the front PERC module. 5. Follow the procedure listed in After working inside your system. Drive bays Removing the drive bay cage blank Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. If installed, remove the front bezel. Steps Using a flat head screwdriver, remove the drive bay cage blank. NOTE: The procedure to remove the drive cage blanks are similar. Installing and removing system components 69
![](/manual_guide/products/dell-poweredge-t550-emc-installation-service-manual-732b751/69.png)
Figure 61. Installing the 2.5-inch drive backplane
Next steps
1.
Install the drives
.
2.
Connect the drive backplane cables to the connector on the backplane.
3.
Install the cooling fan cage.
4.
Install the front PERC module.
5.
Follow the procedure listed in
After working inside your system
.
Drive bays
Removing the drive bay cage blank
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
If installed,
remove the front bezel.
Steps
Using a flat head screwdriver, remove the drive bay cage blank.
NOTE:
The procedure to remove the drive cage blanks are similar.
Installing and removing system components
69