Dell PowerEdge T550 EMC Installation and Service Manual - Page 118
Removing the internal USB module, Installing the internal USB module
View all Dell PowerEdge T550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
Removing the internal USB module Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Remove the air shroud. 4. If you are replacing the internal USB module, remove the internal USB key. Steps Holding the blue pull tab, lift the internal USB module out of the system. Figure 120. Removing the internal USB module Next steps Replace the internal USB module. Installing the internal USB module Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Remove the air shroud. Steps 1. Locate the internal USB connector on the system board. NOTE: For information on the exact location of internal USB on system board, see System board jumpers and connector section. 2. Align internal USB module with the connector on the system board. 3. Press the internal USB module until firmly seated on the system board. 118 Installing and removing system components