Dell PowerEdge T550 EMC Installation and Service Manual - Page 141
Installing the processor
![]() |
View all Dell PowerEdge T550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
Figure 143. Removing the retaining clip Next steps Replace the processor. Installing the processor Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Follow the procedure that is listed in Before working inside your system. 3. Remove the air shroud. 4. Remove the processor heat sink module. Steps 1. Place the processor in the processor tray. NOTE: Ensure the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor. 2. Place the retaining clip on top of the processor in the processor tray aligning pin 1 indicator on the processor. NOTE: Ensure the pin 1 indicator on the retaining clip is aligned with the pin 1 indicator on the processor before placing the retaining clip on the processor. NOTE: Before you install the heat sink, ensure to place the processor and retaining clip in the tray. Installing and removing system components 141
![](/manual_guide/products/dell-poweredge-t550-emc-installation-service-manual-732b751/141.png)