Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 1437
logging synchronous
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1437 highlights
Parameters Defaults Command Modes Command History Usage Information Related Commands To disable this command and return to the default setting, enter no logging source-interface. interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Loopback interfaces, enter the keyword loopback followed by a number from zero (0) to 16383. • For the management interface on the RPM, enter the keyword ManagementEthernet followed by the slot/port information. The slot range is 0-1 and the port range is 0. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For VLAN interface, enter the keyword vlan followed by a number from 1 to 4094. Not configured. CONFIGURATION Version 8.3.19.0 Introduced on S4820T Version 8.3.11.1 Introduced on Z9000 Version 8.3.7.0 Introduced on S4810 Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale. Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Support added for C-Series E-Series legacy command Syslog messages contain the IP address of the interface used to egress the router. By configuring the logging source-interface command, the Syslog packets contain the IP address of the interface configured. logging Enable the logging to another device. logging synchronous c e s z Synchronize unsolicited messages and FTOS output. Simple Network Management Protocol and Syslog | 1437