Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 627
Caution, You can display master/slave settings with
![]() |
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 627 highlights
Example (Master/Slave) FTOS(conf)# int gi 0/0 FTOS(conf-if)#neg auto FTOS(conf-if-autoneg)# ? end Exit from configuration mode exit Exit from autoneg configuration mode mode Specify autoneg mode no Negate a command or set its defaults show Show autoneg configuration information FTOS(conf-if-autoneg)#mode ? forced-master Force port to master mode forced-slave Force port to slave mode FTOS(conf-if-autoneg)# If the mode option is not used, the default setting is slave. If you do not configure forced-master or forced slave on a port, the port negotiates to either a master or a slave state. Port status is one of the following: • Forced-master • Force-slave • Master • Slave • Auto-neg Error-typically indicates that both ends of the node are configured with forced-master or forced-slave. Caution: Ensure that one end of your node is configured as forced-master and one is configured as forced-slave. If both are configured the same (that is forced-master or forced-slave), the show interfaces command will flap between an auto-neg-error and forced-master/slave states. You can display master/slave settings with the show interfaces command. Example (Display Master/ Slave setting) FTOS#show interfaces configured GigabitEthernet 13/18 is up, line protocol is up Hardware is Force10Eth, address is 00:01:e8:05:f7:fc Current address is 00:01:e8:05:f7:fc Interface index is 474791997 Internet address is 1.1.1.1/24 MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 1000 Mbit, Mode full duplex, Master ARP type: ARPA, ARP Timeout 04:00:00 Last clearing of "show interfaces" counters 00:12:42 Queueing strategy: fifo Input Statistics: ... Both sides of the link must have auto-negotiation enabled or disabled for the link to come up. The following table details the possible speed and auto-negotiation combinations for a line between two 10/100/1000 Base-T Ethernet interfaces. Interfaces | 627
![](/manual_guide/products/dell-powerswitch-s4820t-ftos-83190-command-line-reference-guide-s4820t-f2b27fd/627.png)