Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 777

Default Command Modes Command History 3 attempts INTERFACE (management interface only) Version 8.3.19.0 Introduced on the S4820T. Version 8.3.12.0 Introduced on the S4810. ipv6 nd prefix c e s Specify which IPv6 prefixes are included in Neighbor Advertisements. Syntax ipv6 nd prefix {ipv6-prefix | prefix-length | default} [no-advertise] | [no-autoconfig] [no-rtr-address] [off-link] [lifetime {valid | infinite} {preferred | infinite}] Parameters ipv6-prefix prefix-length default no-advertise no-autoconfig no-rtr-address off-link valid-lifetime | infinite preferred-lifetime | infinite Enter an IPv6 prefix. Enter the prefix followed by the prefix length. Range: 0-128 Enter this keyword to set default parameters for all prefixes. Enter this keyword to prevent the specified prefix from being advertised. Enter this keyword to disable Stateless Address Autoconfiguration. Enter this keyword to exclude the full router address from router advertisements (the R bit is not set). Enter this keyword to advertise the prefix without stating to recipients that the prefix is either on-link or off-link. Enter the amount of time that the prefix is advertised, or enter the maximum value for an unlimited amount of time. Default: 2592000 Range: 0 to 4294967295. The maximum value means that the preferred lifetime does not expire for the valid-life time parameter. Enter the amount of time that the prefix is preferred, or enter the maximum value for an unlimited amount of time. Default: 604800 Range: 0 to 4294967295. The maximum value indicates the preferred lifetime does not expire. Command Mode INTERFACE Command History Version 8.3.19.0 Version 8.3.7.0 Version 8.3.2.0 Introduced on the S4820T Introduced on the S4810 Introduced on the E-Series TeraScale, C-Series, and S-Series. IPv6 Basics | 777