Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 612
interface loopback
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 612 highlights
www.dell.com | support.dell.com Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.5.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.4.1.0 Added support for 4-port 40G line cards on ExaScale. Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced Example Usage Information FTOS(conf)#interface gig 0/0 FTOS(conf-if-gi-0/0)#exit# You cannot delete a physical interface. By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To place an interface in mode, ensure that the interface's configuration does not contain an IP address and enter the switchport command. Related Commands interface loopback interface null interface port-channel interface vlan show interfaces Configure a Loopback interface. Configure a Null interface. Configure a port channel. Configure a VLAN. Display interface configuration. interface loopback c e s Configure a Loopback interface. Syntax interface loopback number To remove a loopback interface, use the no interface loopback number command. Parameters number Enter a number as the interface number. Range: 0 to 16383. Defaults Not configured. Command Modes CONFIGURATION Command History Example Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.4.1.0 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced FTOS(conf)#interface loopback 1655 612 | Interfaces