Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 29
ROUTER ISIS Mode, VLT DOMAIN Mode, Intermediate System to,
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the router rip command.The prompt changes to include (conf-router_rip). You can switch to the INTERFACE mode by using the interface command or you can switch to the ROUTER OSPF mode by using the router ospf command. ROUTER ISIS Mode Use the ROUTER ISIS mode to configure ISIS on the E-Series, as described in the E-Series E-Series FTOS Command Line Reference Guide chapter Intermediate System to Intermediate System (IS-IS). To enter ROUTER ISIS mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the router isis [tag] command.The prompt changes to include (conf-router_isis). You can switch to the INTERFACE mode by using the interface command or you can switch to the ROUTER RIP mode by using the router rip command. ROUTER BGP Mode Use the ROUTER BGP mode to configure BGP on the C-Series or E-Series, as described in Chapter 9, Border Gateway Protocol IPv4 (BGPv4). To enter ROUTER BGP mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the router bgp as-number command.The prompt changes to include (conf-router_bgp). You can return to the CONFIGURATION mode by entering the exit command. VLT DOMAIN Mode Use VLT DOMAIN mode to enable and configure the VLT domain protocol, as described in Chapter 57, Virtual Link Trunking (VLT). To enter VLT DOMAIN mode: 1. Verify that you are logged into the CONFIGURATION mode. 2. Enter the config-vlt-domain command. You can return to the CONFIGURATION mode by entering the exit command. CLI Basics | 29