Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 708
management route
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 708 highlights
www.dell.com | support.dell.com Table 24-3. Configurations of the load-balance Command Configuration ip-selection 3-tuple and mac ip-selection packet-based ip-selection packet-based and mac Switched IP Traffic MAC based Packet based: IPV4 No distribution: IPV6 MAC based Routed IP Traffic (IPV4 Only) IP 3-tuple Packet based: IPV4 Packet based: IPV4 Switched Non-IP Traffic MAC based MAC based MAC based Related Commands ip address Change the algorithm used to distribute traffic on an E-Series chassis. management route c e Configure a static route that points to the Management interface or a forwarding router. Syntax management route {ipv4-address | ipv6-address}/mask {forwarding-router-address | managementethernet} Parameters {ipv4-address | ipv6-address}/mask forwarding-router-address managementethernet Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X), followed by the prefix-length for the IP address of the management interface. Enter an IPv4 or IPv6 address of a forwarding router. Enter the keyword managementethernet for the Management interface on the Primary RPM. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.3.19.0 Version 8.4.1.0 Version 8.3.7.0 Version 8.1.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on S4820T Added support for IPv6 management routes. Introduced on S4810 Introduced on E-Series ExaScale Support added for C-Series Introduced for E-Series Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol route) is preferred over the Management Static route. Also, Management static routes and the Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4 and IPv6 management routes. This command manages both tables. 708 | IPv4 Routing