Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 653
show range, show running-config ecmp-group
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 653 highlights
Table 23-9. Diagnostic Data in show interfaces transceiver (continued) Line Tx Power Low Warning Flag Rx Power Low Warning Flag Description This can be either true or false, depending on the Current Tx power value displayed above. This can be either true or false, depending on the Current Rx power value displayed above. Related Commands interface show ip interface show interfaces show inventory (C-Series and E-Series) show inventory (S-Series) Configure a physical interface on the switch. Displays Layer 3 information about the interfaces. Display information on a specific physical interface or virtual interface. Display the chassis type, components (including media), FTOS version including hardware identification numbers and configured protocols. Display the S-Series switch type, components (including media), FTOS version including hardware identification numbers and configured protocols. show range c e s Display all interfaces configured using the interface range command. Syntax show range Command Mode INTERFACE RANGE (config-if-range) Command History Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.1.1.0 Support for 4093 VLANs on E-Series ExaScale Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced Example Related Commands FTOS(conf-if-range-so-2/0-1,fa-0/0)#show range interface sonet 2/0 - 1 interface fastethernet 0/0 FTOS(conf-if-range-so-2/0-1,fa-0/0)# interface show ip interface show interfaces Configure a physical interface on the switch. Displays Layer 3 information about the interfaces. Display information on a specific physical interface or virtual interface. show running-config ecmp-group Display interfaces, LAG, or LAG link bundles being monitored for uneven traffic distribution using the ecmp-group monitoring enable command. The ECMP group could have a LAG or a list of 10G/40 interfaces (not just LAG link-bundles). Interfaces | 653