Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 659
Port Channel Commands, wanport
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 659 highlights
To use the switchport backup interface command on a port, you must first enter the switchport command. For details, the Configuring Redundant Links section in the Layer 2 chapter of the FTOS Configuration Guide. Related Commands interface port-channel show interfaces switchport Create a port channel interface. Display information about switchport interfaces. wanport e Enable the WAN mode on a TenGigabitEthernet interface. Syntax wanport To disable the WAN Port, enter no wanport. Defaults Not configured. Command Modes CONFIGURATION Command History Version 8.1.1.2 pre-Version 6.2.1.0 Introduced on E-Series ExaScale Introduced for E-Series Usage The port must be in a shutdown state to change from LAN mode to WAN mode and Information vice-versa as shown in the figure below. For E-Series ExaScale systems, you must configure all the ports in a port-pipe to either WANPHY or non-WANPHY. They cannot be mixed on the same port-pipe. Example interface TenGigabitEthernet 13/0 no ip address no shutdown FTOS(conf-if-te-13/0)# FTOS(conf-if-te-13/0)#wanport % Error: Port should be in shutdown mode, config ignored Te 13/0. FTOS(conf-if-te-13/0)# FTOS(conf-if-te-13/0)#shutdown FTOS(conf-if-te-13/0)# FTOS(conf-if-te-13/0)#wanport FTOS(conf-if-te-13/0)# Port Channel Commands A Link Aggregation Group (LAG) is a group of links that appear to a MAC client as if they were a single link according to IEEE 802.3ad. In FTOS, a LAG is referred to as a Port Channel. Interfaces | 659