Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 77
Usage, Information, Example, Syntax, Parameters, Defaults, Command Modes, Command, History, Related
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Usage Information Example The following commands are not supported by the do command: • enable • disable • exit • config FTOS(conf-if-te-5/0)#do clear counters Clear counters on all interfaces [confirm] FTOS(conf-if-te-5/0)# FTOS(conf-if-te-5/0)#do clear logging Clear logging buffer [confirm] FTOS(conf-if-te-5/0)# FTOS(conf-if-te-5/0)#do reload System configuration has been modified. Save? [yes/no]: n Proceed with reload [confirm yes/no]: n FTOS(conf-if-te-5/0)# enable c e s Syntax Parameters Defaults Command Modes Command History Usage Information Related Commands Enter the EXEC Privilege mode or any other privilege level configured. After entering this command, you may need to enter a password. enable [level] level (OPTIONAL) Enter a number for a privilege level of FTOS. Range: 0 to 15. Default: 15 15 EXEC Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command Users entering the EXEC Privilege mode or any other configured privilege level can access configuration commands. To protect against unauthorized access, use the enable password command to configure a password for the enable command at a specific privilege level. If no privilege level is specified, the default is privilege level 15. enable password Configure a password for the enable command and to access a privilege level. Control and Monitoring | 77