Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 953
lacp long-timeout
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 953 highlights
Defaults Command Modes Command History interface in | out (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a Ten Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. Optionally, enter an in or out parameter: • Receive enter in • Transmit enter out This command has no default values or behavior EXEC EXEC Privilege Version 8.3.19.0 Version 8.5.1.0 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on S4820T Added support for 4-port 40G line cards on ExaScale. Introduced on S4810 Support added for S-Series Support added for C-Series Introduced on E-Series lacp long-timeout c e Configure a long timeout period (30 seconds) for an LACP session. Syntax Defaults Command Modes Command History lacp long-timeout To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout command. 1 second INTERFACE (conf-if-po-number) Version 8.3.19.0 Version 8.3.7.0 Version 7.6.1.0 Introduced on S4820T Introduced on S4810 Support added for S-Series Link Aggregation Control Protocol (LACP) | 953