Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 411
redistribute ospf, show ip bgp ipv4 multicast
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 411 highlights
redistribute ospf c et s Redistribute OSPF routes into BGP. Syntax redistribute ospf process-id [[match external {1 | 2}] [match internal]] [route-map map-name] To stop redistribution of OSPF routes, use the no redistribute ospf process-id command. Parameters process-id match external {1 | 2} match internal route-map map-name Enter the number of the OSPF process. Range: 1 to 65535 (OPTIONAL) Enter the keywords match external to redistribute OSPF external routes. You can specify 1 or 2 to redistribute those routes only. (OPTIONAL) Enter the keywords match internal to redistribute OSPF internal routes only. (OPTIONAL) Enter the keywords route-map followed by the name of a configured Route map. Defaults Not configured. Command Modes ROUTER BGP Address Family (conf-router_bgp_af) Usage Information When you enter redistribute ospf process-id command without any other parameters, FTOS redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes. This feature is not supported by an RFC. Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.6.1.0 Introduced support on S-Series Introduced support on C-Series Introduced IPv6 MGBP support for E-Series show ip bgp ipv4 multicast c et s View the current MBGP routing table for the system. Syntax show ip bgp ipv4 multicast [detail | network [network-mask] [length]] Parameters detail network (OPTIONAL) Enter the keyword detail to display BGP internal information for the IPv4 Multicast address family. (OPTIONAL) Enter the network address (in dotted decimal format) of the BGP network to view information only on that network. Border Gateway Protocol IPv4 (BGPv4) | 411