Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 180
dot1x supplicant-timeout
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 180 highlights
www.dell.com | support.dell.com Command History Usage Information Version 8.3.19.0 Version 8.3.12.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on the S4820T Introduced on the S4810 Introduced on C-Series and S-Series Introduced on E-Series When you configure the dot1x server-timeout value, you must take into account the communication medium used to communicate with an authentication server and the number of RADIUS servers configured. Ideally, the dot1x server-timeout value (in seconds) is based on the configured RADIUS-server timeout and retransmit values and calculated according to the following formula: dot1x server-timeout seconds > (radius-server retransmit seconds + 1) * radius-server timeout seconds Where the default values are as follows: dot1x server-timeout (30 seconds), radius-server retransmit (3 seconds), and radius-server timeout (5 seconds). For example: FTOS(conf)#radius-server host 10.11.197.105 timeout 6 FTOS(conf)#radius-server host 10.11.197.105 retransmit 4 FTOS(conf)#interface gigabitethernet 2/23 FTOS(conf-if-gi-2/23)#dot1x server-timeout 40 dot1x supplicant-timeout c e s Configure the amount of time after which exchanges with the supplicant time out. Syntax Parameters Defaults Command Modes Command History dot1x supplicant-timeout seconds To return to the default, use the no dot1x supplicant-timeout command. seconds Enter a time-out value in seconds. Range: 1 to 300, where 300 is implementation dependant. Default: 30 30 seconds INTERFACE Version 8.3.19.0 Version 8.3.12.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on the S4820T Introduced on the S4810 Introduced on C-Series and S-Series Introduced on E-Series 180 | 802.1X