Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 360
network
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 360 highlights
www.dell.com | support.dell.com Syntax Parameters Defaults Command Modes Usage Information neighbor {ip-address | peer-group-name} weight weight To remove a weight value, use the no neighbor {ip-address | peer-group-name} weight command. ip-address peer-group-name weight Enter the IP address of the peer router in dotted decimal format. Enter the name of the peer group to disable all routers within the peer group. Enter a number as the weight. Range: 0 to 65535 Default: 0 0 ROUTER BGP In the FTOS best path selection process, the path with the highest weight value is preferred. Note: Reset the neighbor connection (clear ip bgp * command) to apply the weight to the connection and recompute the best path. Related Commands Command History If the set weight command is configured in a route map applied to this neighbor, the weight set in that command overrides the weight set in the neighbor weight command. set weight Assign a weight to all paths meeting the route map criteria. Version 8.3.19.0 Version 8.3.7.0 Version 7.8.1.0 Version 7.7.1.0 Introduced on the S4820T. Introduced on the S4810. Introduced support on S-Series Introduced support on C-Series network c e s Specify the networks for the BGP process and enter them in the BGP routing table. Syntax network ip-address mask [route-map map-name] To remove a network, use the no network ip-address mask [route-map map-name] command. 360 | Border Gateway Protocol IPv4 (BGPv4)