Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 829
To prevent loops, the, command will not install default routes
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 829 highlights
Related Commands neighbor filter-list neighbor route-map Assign a AS-PATH list to a neighbor or peer group. Assign a route map to a neighbor or peer group. neighbor ebgp-multihop c e Attempt and accept BGP connections to external peers on networks that are not directly connected. Syntax Parameters Defaults Command Modes Command History Usage Information neighbor {ipv6-address | peer-group-name} ebgp-multihop [ttl] To disallow and disconnect connections, use the no neighbor {ipv6-address | peer-group-name} ebgp-multihop [ttl] command. ipv6-address peer-group-name ttl Disabled. ROUTER BGP Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group. (OPTIONAL) Enter the number of hops as the Time to Live (ttl) value. Range: 1 to 255. Default: 255 Version 8.3.19.0 Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on S4820T Introduced on C-Series and S4810 Introduced on E-Series ExaScale Introduced on E-Series TeraScale To prevent loops, the neighbor ebgp-multihop command will not install default routes of the multihop peer. Networks not directly connected are not considered valid for best path selection. neighbor fall-over c e Enable or disable fast fall-over for BGP neighbors. Syntax neighbor {ipv6-address | peer-group-name} fall-over To disable, use the no neighbor {ipv6-address | peer-group-name} fall-over command. IPv6 Border Gateway Protocol (IPv6 BGP) | 829