Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 1454
show storm-control broadcast
View all Dell PowerSwitch S4820T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1454 highlights
www.dell.com | support.dell.com • When storm control is applied on an interface, the percentage of storm control applied is calculated based on the advertised rate of the line card. It is not based on the speed setting for the line card. • Do not apply per-VLAN QoS on an interface that has storm control enabled (either on an interface or globally). • When broadcast storm control is enabled on an interface or globally on ingress, and DSCP marking for a DSCP value 1 is configured for the data traffic, the traffic will go to queue 1 instead of queue 0. • Similarly, if unicast storm control is enabled on an interface or globally on ingress, and DSCP marking for a DSCP value 2 is configured for the data traffic, the traffic will go to queue 2 instead of queue 0. Note: Bi-directional traffic (unknown unicast and broadcast), along with egress storm control, causes the configured traffic rates to be split between the involved ports. The percentage of traffic that each port receives after the split is not predictable. These ports can be in the same/different port pipes, or the same/different line cards. show storm-control broadcast c e s Display the storm control broadcast configuration. Syntax Parameters Defaults Command Modes Command History show storm-control broadcast [interface] interface (OPTIONAL) Enter one of the following interfaces to display the interface specific storm control configuration. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • Fast Ethernet is not supported. No default behavior or values EXEC EXEC Privilege Version 8.3.19.0 Version 8.5.1.0 Version 8.3.7.0 Version 7.6.1.0 Introduced on S4820T Added support for 4-port 40G line cards on ExaScale. Introduced on S4810 Introduced on S-Series 1454 | Storm Control