Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 226

www.dell.com | support.dell.com Defaults Command Modes Command History operator port port destination mask count byte log order monitor fragments (OPTIONAL) Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two port for the port parameter.) Enter the application layer port number. Enter two port numbers if using the range logical operand. Range: 0 to 65535. The following list includes some common TCP port numbers: 23 = Telnet 20 and 21 = FTP 25 = SMTP 169 = SNMP Enter the IP address of the network or host to which the packets are sent. Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in the log. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. Range: 0-254 (where 0 is the highest priority and 254 is the lowest; lower order numbers have a higher priority) Default: If the order keyword is not used, the ACLs have the lowest order by default (255). (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule will be applied to the monitored interface. For details, refer to the section "Flow-based Monitoring" in the Port Monitoring chapter of the FTOS Configuration Guide. Enter the keyword fragments to use ACLs to control packet fragments. Not configured. CONFIGURATION-EXTENDED-ACCESS-LIST Version 8.3.1.0 Version 8.2.1.0 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Added dscp keyword. Allows ACL control of fragmented packets for IP (Layer 3) ACLs. Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series 226 | Access Control Lists (ACL)