Dell PowerSwitch S4820T FTOS 8.3.19.0 Command Line Reference Guide for the S48 - Page 438

www.dell.com | support.dell.com cam-acl-egress (Configuration) c s Select the FP groups for CAM access control lists for Layer 2, IPv4 and IPv6 ACLs. Syntax cam-acl-egress {default | l2acl number ipv4acl number ipv6acl number} Parameters default l2acl number ipv4acl number ipv6acl number Reset the egress CAM ACL entries to the default settings. Allocate space to each CAM region. Enter the CAM profile name followed by the amount of CAM space to be allotted. The total space allocated must equal 13. l2acl range: 1 to 4 ipv4acl range: 1 to 4 ipv6acl range: 0 to 4 Command Modes CONFIGURATION Command History Version 8.3.19.0 Version 8.3.10.0 Version 8.3.1.0 Version 8.2.1.0 Version 7.8.1.0 Introduced on the S4820T Introduced on the S4810 Added ecfmacl, vman-qos, and vman-dual-qos keywords. Introduced on the S-Series Introduced on the C-Series Usage Information You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system for the new settings to take effect. There are 4 groups total. You must allocate at least one group for L2ACL and IPv4 ACL. Ranges for the CAM profiles are 1 to 4 for l2acl. The range for the ipv6acl profile is 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10). cam-acl (EXEC Privilege) c s Adjust linecard CAM setting to match chassis settings. This command is deprecated as of FTOS 8.3.1.0 Syntax cam-acl {chassis |linecard} Command Modes EXEC Privilege Command History Version 8.3.1.0 Version 7.8.1.0 COMMAND DEPRECATED Introduced on the C-Series 438 | Content Addressable Memory (CAM)