Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 108

! logging server 10.22.0.99 Post-ZTD script As a general guideline, use a post-ZTD script to perform any additional functions required to configure and operate the switch. In the ZTD provisioning script, specify the post-ZTD script path for the POST_SCRIPT_FILE variable. You can use a script to notify an orchestration server that the ZTD configuration is complete. The server can then configure additional settings on the switch. For example, during the ZTD phase, you can configure only a management VLAN and IP address, then allow an Ansible orchestration server to perform complete switch configuration. Here is a sample curl script that is included in the post-ZTD script to contact an Ansible server: /usr/bin/curl -H "Content-Type:application/json" -k -X POST --data '{"host_config_key":"'7d07e79ebdc8f7c292e495daac0fe16b'"}' -u admin:admin https://10.16.134.116/api/v2/job_templates/9/callback/ ZTD commands reload ztd Reboots the switch and enables ZTD after the reload. Syntax Parameters Default Command Mode Usage Information Example reload ztd None ZTD is enabled. EXEC Use the reload ztd command to automatically upgrade OS10 and/or activate new configuration settings. When you reload ZTD, you are prompted to confirm the deletion of the startup configuration. OS10# reload ztd Supported Releases 10.4.1.0 or later show ztd-status Displays the current ZTD status: enabled, disabled, or canceled. Syntax Parameters Default Command Mode Usage Information Examples show ztd-status None None EXEC None OS10# show ztd-status ZTD Status : disabled ZTD State : completed Protocol State : idle 108 Dell EMC SmartFabric OS10 zero-touch deployment