Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 609

bfd interval Configures parameters for all BFD sessions on the switch. Syntax Parameters bfd interval milliseconds min_rx milliseconds multiplier number role {active | passive} ● interval milliseconds - Enter the time interval for sending control packets to BFD peers; from 50 to 1000. Dell EMC recommends using more than 100 milliseconds. ● min_rx milliseconds - Enter the maximum waiting time for receiving control packets from BFD peers, from 50 to 1000. Dell EMC recommends using more than 100 milliseconds. ● multiplier number - Enter the number of consecutive packets that can be missed from a BFD peer before the session state changes to Down, from 3 to 50. ● role {active | passive} - Enter active if the router initiates BFD sessions. Both BFD peers can be active at the same time. Enter passive if the router does not initiate BFD sessions, and only responds to a request from an active BFD to initialize a session. Default The time interval for sending control packets to BFD peers is 200 milliseconds. The maximum waiting time for receiving control packets from BFD peers is 200 milliseconds. The number of consecutive packets that must be received from a BFD peer is 3. The BFD role is active. Command Mode Usage Information CONFIGURATION Use this command to configure global BFD session settings. To configure the BFD parameters used in sessions established with neighbors discovered by an L3 protocol, use the bfd all-neighbors command. The no version of this command deletes the configured global settings and returns to the default values. If you enable BFD on a specific static route, use the bfd interval command to configure the BFD parameters for that specific static route. Example OS10(config)# bfd interval 250 min_rx 300 multiplier 4 role passive Supported releases 10.4.1.0 or later ip ospf bfd all-neighbors Enables and configures the default BFD parameters for all OSPFv2 neighbors in this interface. Syntax Parameters ip ospf bfd all-neighbors [disable|[interval millisec min_rx min_rx multiplier role {active | passive}]] ● disable - Disables the BFD session on an interface alone. ● interval milliseconds - Enter the time interval for sending control packets to BFD peers, from 100 to 1000. Dell EMC recommends using more than 100 milliseconds. ● min_rx milliseconds - Enter the maximum waiting time for receiving control packets from BFD peers, from 100 to 1000. Dell EMC recommends using more than 100 milliseconds. ● multiplier number - Enter the maximum number of consecutive packets that must not be received from a BFD peer before the session state changes to Down, from 3 to 50. ● role {active | passive} - Enter active if the router initiates BFD sessions. Both BFD peers can be active at the same time. Enter passive if the router does not initiate BFD sessions, and only responds to a request from an active BFD to initialize a session. Default The time interval for sending control packets to BFD peers is 200 milliseconds. The maximum waiting time for receiving control packets from BFD peers is 200 milliseconds. The number of consecutive packets that must be received from a BFD peer is 3. Layer 3 609