Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 787

Usage Information Example Supported Releases ● Before you enable IPsec authentication on an OSPFv3 interface, you must enable IPv6 unicast routing globally, configure an IPv6 address and enable OSPFv3 on the interface, and assign it to an area. ● When you configure encryption on an interface, both IPsec encryption and authentication are enabled. You cannot configure encryption if you have already configured an interface for IPsec authentication using the ipv6 ospf authentication ipsec command. To configure encryption, you must first delete the authentication policy. ● All neighboring OSPFv3 routers must share the same encryption key to decrypt information. Only a non-encrypted key is supported. Required lengths of the non-encrypted key are: 3DES - 48 hex digits; DES - 16 hex digits; AES-CBC - 32 hex digits for AES-128 and 48 hex digits for AES-192. ● All neighboring OSPFv3 routers must share the same authentication key to exchange information. Only a non-encrypted key is supported. For MD5 authentication, the non-encrypted key must be 32 plain hex digits. For SHA1 authentication, the non-encrypted key must be 40 hex digits. An encrypted key is not supported. OS10(config)# interface ethernet 1/1/6 OS10(conf-if-eth1/1/6)# ipv6 ospf encryption ipsec spi 500 esp des 1234567812345678 md5 12345678123456781234567812345678 OS10(config)# interface ethernet 1/1/5 OS10(conf-if-eth1/1/5)# ipv6 ospf encryption null 10.4.0E(R1) or later ipv6 ospf hello-interval Sets the time interval between hello packets sent on an interface. Syntax Parameters Default Command Mode Usage Information Example ipv6 ospf hello-interval seconds seconds - Enter the hello-interval value in seconds, from 1 to 65535. 10 seconds INTERFACE All routers in a network must have the same hello time interval between the hello packets. The no version of the this command resets the value to the default. OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf hello-interval 30 Supported Releases 10.3.0E or later ipv6 ospf mtu-ignore Disables MTU size detection on received Database Descriptor (DBD) packets when forming OSPFv3 adjacency. Syntax Parameters Default Command Mode Usage Information ipv6 ospf mtu-ignore None Not configured INTERFACE If the MTU size of the peer interface is greater than the local interface, switches that run OSPFv3 do not form adjacencies with neighbors. Use this command to override this behavior and form adjacency. If you try to disable a neighborship using the no ipv6 ospf mtu-ignore command after a neighborship is formed using the ipv6 ospf mtu-ignore command, the neighborship still continues. Layer 3 787