Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 1468

Command Mode Usage Information Example INTERFACE In Auto mode, a DCBX-enabled port detects an incompatible DCBX version on a peer device port and automatically reconfigures a compatible version on the local port. The no version of this command disables the DCBX version. OS10(conf-if-eth1/1/2)# dcbx version cee Supported Releases 10.3.0E or later debug dcbx Enables DCBX debugging. Syntax Parameters debug dcbx {all | events | tlv} [interface ethernet node/slot/port] ● all-Enables all DCBX debugging logs. ● events-Enables DCBX-event-related logs. ● tlv-Enables DCBX TLV-related logs. ● interface ethernet node/slot/port-Enter the interface information for which you want to collect the DCBX debug logs. Defaults Command Mode Security and Access Usage Information Disabled EXEC Netadmin and sysadmin Before you use the debug dcbx command, ensure that you run the following commands: ● logging enable ● logging console enable ● terminal monitor OS10 does not support the interface range option with this command. Example OS10# debug dcbx tlv Supported Releases 10.5.1.0 or later lldp tlv-select dcbxp Enables and disables DCBX on a port interface. Syntax Parameters Default Command Mode Usage Information Example lldp tlv-select dcbxp None Enabled interface level; disabled global level INTERFACE DCBX must be enabled at both the global and interface levels. Enable DCBX globally using the dcbx enable command to activate the exchange of DCBX TLV messages with PFC, ETS, and iSCSI configurations. To configure the TLVs advertised by a DCBX-enabled port, change the DCBX version, or disable DCBX on an interface, use DCBX interface-level commands. The no version of this command disables DCBX on an interface. OS10(conf-if-eth1/1/1)# lldp tlv-select dcbxp 1468 Converged data center services