Dell PowerSwitch S5212F-ON EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 786

ipv6 ospf cost Changes the cost associated with the OSPFv3 traffic on an interface Syntax Parameters Default Command Mode Usage Information Example ipv6 ospf cost cost cost - Enter a value as the OSPFv3 cost for the interface, from 1 to 65335. Based on bandwidth reference INTERFACE If not configured, the interface cost is based on the auto-cost command. This command configures OSPFv3 over multiple vendors to ensure that all routers use the same cost value. The no version of this command removes the IPv6 OSPF cost configuration. OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf cost 10 Supported Releases 10.3.0E or later ipv6 ospf dead-interval Sets the time interval since the last hello-packet was received from a router. After the interval elapses, the neighboring routers declare the router dead. Syntax Parameters Default Command Mode Usage Information Example ipv6 ospf dead-interval seconds seconds - Enter the dead interval value in seconds, from 1 to 65535. 40 seconds INTERFACE The dead interval is four times the default hello-interval by default. The no version of this command resets the value to the default. OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf dead-interval 10 Supported Releases 10.3.0E or later ipv6 ospf encryption Configures OSPFv3 encryption on an IPv6 interface. Syntax Parameters ipv6 ospf encryption {ipsec spi number esp encryption-type key authentication-type key | null} ● ipsec spi number - Enter a unique security policy index number, from 256 to 4294967295. ● esp encryption-type - Enter the encryption algorithm used with ESP (3DES, DES, AES-CBC, or NULL). For AES-CBC, only the AES-128 and AES-192 ciphers are supported. ● key - Enter the text string used in the encryption algorithm. ● authentication-type - Enter the encryption MD5 or SHA1 authentication algorithm to use. ● key - Enter the text string used in the authentication algorithm. ● null - Enter the keyword to not use the IPsec encryption. Default IPv6 OSPF encryption is not configured on an interface. Command Mode INTERFACE 786 Layer 3